Ignition Coil For 2017-2018 -Toyota Yaris IA L4 1.5L Sedan 2019 Yaris L4 1.5L

Specifications

Voltage

12V

Connector Gender

Female

Terminal Gender

Male

Terminal Type

Blade

Spark Plug Material

Iridium

Thread Diameter(mm)

12.0

Thread Length(mm)

26.5

Manufacturer Heat Range

7.0

Interchange Part Numbers

93501

Fitment

2016-2016 iA L4 1.5L Sedan

2019-2019 Yaris L4 1.5L SKYACTIV

2017-2018 Yaris iA L4 1.5L Sedan

Features

Built to strict quality control standards 100% factory tested

IATF16949

100% Compatible with OEM Parts, meets Original Equipment Manufacturer (OEM) Standards

Direct replacement

100% pure copper windings in bobbins improve durability ,thermoplastic housing withstands heat stress for enhanced durability

Spark Plugs are using High-Performance Iridium metal, Much better than Nickel and Platinum

It's suggested that ignition coil and spark plug be replaced in a sychronized manner to lower the likelihood of common ignition system dysfunctions such as failure to start，engine vibration, misfiring, inadequate power ,spark plug fouling and poor fuel economy

Attention

How to Change Ignition Coils and Spark Plugs?

1.Disconnect the old ignition coil and spark plugs

2.Disconnect your battery’s negative terminal

3.Locate the ignition coil and spark plugs to be replaced.

4.Release the clip on the plug running into the side of coil.

5.Use a wrench to unscrew the bolts holding the original coil in place

6.Extract original ignition coil and spark plugs from the engine bay

7.Swapping in the new ignition coil and spark plugs

8.Prior to installation, compare the new coil to the old one

9.Orient the new coil in the same direction

10.Insert the bolts to hold the coil in place

11.Activate the New ignition coil and spark plugs

12.Connect the plug into the side coil

13.Plug in ignition cables according to the order written on them.

14.Reconnect the battery

15.Start the vehicle to test the new ignition coil and spark plugs

Note

In preparation for the replacement, the vehicle should be turned off and cooled for a certain period of time before starting the replacement.

pay attention to the cleanliness of the entire operation, must wipe the ignition coil around the dust and oil, if into the combustion chamber, will have serious adverse effects, try to wear gloves to operate.